Preparation and characterization of FeTiO3-Fe2O 3 solid solution system

Miki Yamashita, Makoto Nakanishi, Tatsuo Fujii, Jun Takada, Hideki Yoshikawa, Yuuji Saitoh, Shin Ichi Fujimori, Keisuke Kobayashi

Research output: Chapter in Book/Report/Conference proceedingConference contribution

Abstract

The ilmenite-hematite solid-solution, xFeTiO3-(1-x) α-Fe2O3 samples with x=0.7-1.0. were prepared by standard solid state reaction technique in an evaculated quartz tube. The sample pellets were heated at 1200°C for 24 hr, then furnance cooled to room temperature1. All samples consisted of a single phase of ilmenite structure. Lattice parameters of these samples estimated from the XRD patterns varied linearly with decreasing the Ti concentration on the basis of the Vegard's law. The saturating magnetization at 78 K was obtained at x=0.8 (Fe1.2Ti0.8O3), and the sample with x=0.7 (Fe1.3Ti0.7O3) was ferrimagnetic at room temperature. The carrier type measured by Seebeck coefficient was changed from p-type to n-type at about x=0.78 with decreasing the Ti concentration. Electronic states of Fe and Ti ions in FeTiO3 seemingly had the characteristic features of Fe2+ and Ti4+ respectively. However the Ti 2p→3p resonant valence band photoemission spectra of FeTiO3 had a clear density assigned to the Ti 3 d derived states. The small density appeared just below the Fermi edge was intrinsic for the FeTiO3 crystals because of identical x-ray absorption spectrum at Ti L2,3 edges between constant initial state and total electron yield mode.

Original languageEnglish
Title of host publicationCeramic Transactions
Pages505-512
Number of pages8
Volume196
Publication statusPublished - 2006
Event6th Pacific Rim Conference on Ceramic and Glass Technology - Maui, Hawaii, United States
Duration: Sep 11 2005Sep 16 2005

Publication series

NameCeramic Transactions
Volume196
ISSN (Print)10421122

Other

Other6th Pacific Rim Conference on Ceramic and Glass Technology
CountryUnited States
CityMaui, Hawaii
Period9/11/059/16/05

Fingerprint

Ilmenite
Solid solutions
Quartz
Seebeck coefficient
Hematite
Photoemission
Electronic states
Valence bands
Solid state reactions
Lattice constants
Absorption spectra
Magnetization
Ions
X rays
Crystals
Electrons
Temperature
ilmenite
ferric oxide

ASJC Scopus subject areas

  • Ceramics and Composites

Cite this

Yamashita, M., Nakanishi, M., Fujii, T., Takada, J., Yoshikawa, H., Saitoh, Y., ... Kobayashi, K. (2006). Preparation and characterization of FeTiO3-Fe2O 3 solid solution system. In Ceramic Transactions (Vol. 196, pp. 505-512). (Ceramic Transactions; Vol. 196).

Preparation and characterization of FeTiO3-Fe2O 3 solid solution system. / Yamashita, Miki; Nakanishi, Makoto; Fujii, Tatsuo; Takada, Jun; Yoshikawa, Hideki; Saitoh, Yuuji; Fujimori, Shin Ichi; Kobayashi, Keisuke.

Ceramic Transactions. Vol. 196 2006. p. 505-512 (Ceramic Transactions; Vol. 196).

Research output: Chapter in Book/Report/Conference proceedingConference contribution

Yamashita, M, Nakanishi, M, Fujii, T, Takada, J, Yoshikawa, H, Saitoh, Y, Fujimori, SI & Kobayashi, K 2006, Preparation and characterization of FeTiO3-Fe2O 3 solid solution system. in Ceramic Transactions. vol. 196, Ceramic Transactions, vol. 196, pp. 505-512, 6th Pacific Rim Conference on Ceramic and Glass Technology, Maui, Hawaii, United States, 9/11/05.
Yamashita M, Nakanishi M, Fujii T, Takada J, Yoshikawa H, Saitoh Y et al. Preparation and characterization of FeTiO3-Fe2O 3 solid solution system. In Ceramic Transactions. Vol. 196. 2006. p. 505-512. (Ceramic Transactions).
Yamashita, Miki ; Nakanishi, Makoto ; Fujii, Tatsuo ; Takada, Jun ; Yoshikawa, Hideki ; Saitoh, Yuuji ; Fujimori, Shin Ichi ; Kobayashi, Keisuke. / Preparation and characterization of FeTiO3-Fe2O 3 solid solution system. Ceramic Transactions. Vol. 196 2006. pp. 505-512 (Ceramic Transactions).
@inproceedings{976cc66175224424b51f6800f7d12ae5,
title = "Preparation and characterization of FeTiO3-Fe2O 3 solid solution system",
abstract = "The ilmenite-hematite solid-solution, xFeTiO3-(1-x) α-Fe2O3 samples with x=0.7-1.0. were prepared by standard solid state reaction technique in an evaculated quartz tube. The sample pellets were heated at 1200°C for 24 hr, then furnance cooled to room temperature1. All samples consisted of a single phase of ilmenite structure. Lattice parameters of these samples estimated from the XRD patterns varied linearly with decreasing the Ti concentration on the basis of the Vegard's law. The saturating magnetization at 78 K was obtained at x=0.8 (Fe1.2Ti0.8O3), and the sample with x=0.7 (Fe1.3Ti0.7O3) was ferrimagnetic at room temperature. The carrier type measured by Seebeck coefficient was changed from p-type to n-type at about x=0.78 with decreasing the Ti concentration. Electronic states of Fe and Ti ions in FeTiO3 seemingly had the characteristic features of Fe2+ and Ti4+ respectively. However the Ti 2p→3p resonant valence band photoemission spectra of FeTiO3 had a clear density assigned to the Ti 3 d derived states. The small density appeared just below the Fermi edge was intrinsic for the FeTiO3 crystals because of identical x-ray absorption spectrum at Ti L2,3 edges between constant initial state and total electron yield mode.",
author = "Miki Yamashita and Makoto Nakanishi and Tatsuo Fujii and Jun Takada and Hideki Yoshikawa and Yuuji Saitoh and Fujimori, {Shin Ichi} and Keisuke Kobayashi",
year = "2006",
language = "English",
isbn = "047008295X",
volume = "196",
series = "Ceramic Transactions",
pages = "505--512",
booktitle = "Ceramic Transactions",

}

TY - GEN

T1 - Preparation and characterization of FeTiO3-Fe2O 3 solid solution system

AU - Yamashita, Miki

AU - Nakanishi, Makoto

AU - Fujii, Tatsuo

AU - Takada, Jun

AU - Yoshikawa, Hideki

AU - Saitoh, Yuuji

AU - Fujimori, Shin Ichi

AU - Kobayashi, Keisuke

PY - 2006

Y1 - 2006

N2 - The ilmenite-hematite solid-solution, xFeTiO3-(1-x) α-Fe2O3 samples with x=0.7-1.0. were prepared by standard solid state reaction technique in an evaculated quartz tube. The sample pellets were heated at 1200°C for 24 hr, then furnance cooled to room temperature1. All samples consisted of a single phase of ilmenite structure. Lattice parameters of these samples estimated from the XRD patterns varied linearly with decreasing the Ti concentration on the basis of the Vegard's law. The saturating magnetization at 78 K was obtained at x=0.8 (Fe1.2Ti0.8O3), and the sample with x=0.7 (Fe1.3Ti0.7O3) was ferrimagnetic at room temperature. The carrier type measured by Seebeck coefficient was changed from p-type to n-type at about x=0.78 with decreasing the Ti concentration. Electronic states of Fe and Ti ions in FeTiO3 seemingly had the characteristic features of Fe2+ and Ti4+ respectively. However the Ti 2p→3p resonant valence band photoemission spectra of FeTiO3 had a clear density assigned to the Ti 3 d derived states. The small density appeared just below the Fermi edge was intrinsic for the FeTiO3 crystals because of identical x-ray absorption spectrum at Ti L2,3 edges between constant initial state and total electron yield mode.

AB - The ilmenite-hematite solid-solution, xFeTiO3-(1-x) α-Fe2O3 samples with x=0.7-1.0. were prepared by standard solid state reaction technique in an evaculated quartz tube. The sample pellets were heated at 1200°C for 24 hr, then furnance cooled to room temperature1. All samples consisted of a single phase of ilmenite structure. Lattice parameters of these samples estimated from the XRD patterns varied linearly with decreasing the Ti concentration on the basis of the Vegard's law. The saturating magnetization at 78 K was obtained at x=0.8 (Fe1.2Ti0.8O3), and the sample with x=0.7 (Fe1.3Ti0.7O3) was ferrimagnetic at room temperature. The carrier type measured by Seebeck coefficient was changed from p-type to n-type at about x=0.78 with decreasing the Ti concentration. Electronic states of Fe and Ti ions in FeTiO3 seemingly had the characteristic features of Fe2+ and Ti4+ respectively. However the Ti 2p→3p resonant valence band photoemission spectra of FeTiO3 had a clear density assigned to the Ti 3 d derived states. The small density appeared just below the Fermi edge was intrinsic for the FeTiO3 crystals because of identical x-ray absorption spectrum at Ti L2,3 edges between constant initial state and total electron yield mode.

UR - http://www.scopus.com/inward/record.url?scp=33751405413&partnerID=8YFLogxK

UR - http://www.scopus.com/inward/citedby.url?scp=33751405413&partnerID=8YFLogxK

M3 - Conference contribution

SN - 047008295X

SN - 9780470082959

VL - 196

T3 - Ceramic Transactions

SP - 505

EP - 512

BT - Ceramic Transactions

ER -