Corrosion characteristics of a tungsten alloy die-casting mould material in molten aluminium alloy

Research output: Contribution to journalArticlepeer-review

Abstract

To understand the corrosion characteristics of W90 tungsten alloy and compare them with those of conventional hot-worked steel (SKD61), immersion tests were carried out in molten aluminium alloy (ADC12). Severe corrosion occurred in SKD61, whereas the corrosion resistance of W90 was about 40 times greater, with little occurring even after 300 h immersion. However, significant microstructural changes occurred in W90 resulting from penetration of aluminium and silicon through grain boundaries to create WAl5 and WSi2 phases, detectable even after a few hours’ immersion. Relatively soft (hardness 1.5 GPa) WAl5 formed between the W based grains, and hard (10 GPa) WSi2 outside the W based grains. Tensile strength decreased slowly with increasing immersion time, while a significant reduction in fracture strain occurred. These changes in tensile properties were caused by the microstructural changes, e.g. soft and brittle intermetallic compounds. Crack propagated along the WAl5 phases (intergranular fracture), whereas transgranular fracture was dominant for uncorroded or less corroded W90.

Original languageEnglish
Pages (from-to)162-168
Number of pages7
JournalInternational Journal of Cast Metals Research
Volume31
Issue number3
DOIs
Publication statusPublished - May 4 2018

Keywords

  • Die-casting mould
  • aluminium alloy
  • corrosion
  • mechanical property
  • tungsten

ASJC Scopus subject areas

  • Mechanics of Materials
  • Mechanical Engineering
  • Metals and Alloys

Fingerprint Dive into the research topics of 'Corrosion characteristics of a tungsten alloy die-casting mould material in molten aluminium alloy'. Together they form a unique fingerprint.

Cite this