Surface cleaning using a high-speed air jet can be applied for the removal of solid particulate contaminants adhering to a solid surface. An air jet is applied to the surface and the air blows off the particle contaminant. The physical mechanism causing the removal is resuspension of particles from a solid surface. The resuspension phenomenon has been studied by means of tube flow. However, the model of the resuspension phenomenon has not yet been established. Thus, the removal efficiency of the highspeed air-jet method cannot be estimated theoretically. Therefore, the present chapter focuses on empirical knowledge. The results are presented on the several studies with particular attention to the effect of operating conditions on the removal efficiency. The data given in this chapter were obtained from experiments using monodispersed standard latex particles (styrene/divinyl benzene) as test particles and borosilicate glass as a standard surface. The test particles were deposited by sedimentation in air. After deposition, the test piece was dried for more than 100 hours in a desiccator. For all experiments, the test piece was transferred to a controlled removal environment, and the removal experiment was conducted after leaving the test piece in the environment for two minutes or longer.
|Title of host publication||Developments in Surface Contamination and Cleaning|
|Subtitle of host publication||Fundamentals and Applied Aspects|
|Number of pages||29|
|Publication status||Published - Dec 3 2007|
ASJC Scopus subject areas
- Chemical Engineering(all)